The 1746-QS is the synchronized axis control module for SLC 500 racks. It reads four linear displacement transducers and drives four analog outputs, with connections through a 1492-AIFMQS interface, and it handles position feedback down to a 220-inch input range.
Keeping moving parts in step
Machines with several position axes that must move together, such as multi-point clamping, synchronized lifts, or web-handling guides, need control that compares positions faster than a normal PLC scan can. The QS closes that loop on the module itself: it watches the magnetostrictive transducers and corrects the analog outputs continuously, so all four axes hold registration with each other rather than each chasing the scan in its own time.
Key specifications
| Manufacturer | Allen-Bradley |
| Product family | SLC 500 (1746/1747) |
| Product type | PLC Module |
| Product Code | 1746-QS |
| LDT Inputs | 4 |
| Analog Outputs | 4 |
| I/O Connection | 1492-AIFMQS |
| Input Frequency | 220 inches |
| Place of Origin | Made in USA |
| Backplane Current | Not available |
| Mounting | 1746 chassis (4, 7, 10, 13 or 16 slot) |
| Backplane supply | SLC 500 parallel backplane |
| Enclosure rating | Open style, IP20 |
| Operating temperature | 0 to 60 °C (32 to 140 °F) |
| Storage temperature | -40 to 85 °C (-40 to 185 °F) |
| Relative humidity | 5 to 95%, non-condensing |
| Certifications | CE, cULus |
| Condition | Tested and cleaned, in good working order |
| Warranty | 12 months |
| Stock status | In stock |
Registration checks that catch drift early
Synchronized axes drift apart slowly as transducers and output stages age, so schedule a registration check: jog all four axes to a known reference and compare their reported positions, then run a slow synchronized move and watch the spread. A growing spread points at a transducer or a channel, not at the machine geometry, and catching it early avoids scrap. Keep the transducer start and stop positions recorded from commissioning, because recalibrating after a replacement needs those numbers. The 1492 interface connections deserve a look during the same routine, since vibration works connectors loose over the years. Document all of it in one procedure so any technician can run it.
Commissioning notes
The LDT wiring lands through the 1492-AIFMQS interface, so plan that interface into the panel drawing from the start. Confirm transducer start and stop positions against the module setup before first motion, and verify each axis direction with a slow jog. Spares for machines built around this module should include the 1492 interface as well, since the QS is useless without its cabling plan.
One more habit worth building: photograph the transducer mounting and the 1492 interface wiring at commissioning, because those photos answer the questions that come up after a machine rebuild.













