Mixed Sensor Inputs
Mixed temperature cabinets, some RTDs, some thermocouples, some millivolt transducers, are where the 1756-IRT8I earns its slot with eight isolated points in one 1756 chassis. It accepts RTD, thermocouple or millivolt signals per channel, replacing two or three single-type cards. Each point is isolated, so a ground fault on one sensor cannot disturb its neighbors. The module is open style, IP20, CE and cULus listed, and made in the USA.
Isolation And Power
Eight isolated channels are configured individually for RTD, thermocouple or millivolt, so one card covers a whole mixed-sensor group and trims spare stock. Isolation per point keeps a bad sensor from dragging the others or the backplane down. Backplane current is 250 mA at 5 V and 150 mA at 24 V, with maximum power dissipation of 4.6 W, which is easy on the chassis budget. Operating range is 0 to 60 °C with 5 to 95% non-condensing humidity, suiting a standard control room.
Fit And Check
This module is the choice for a panel with mixed temperature types, because one card replaces separate RTD and thermocouple modules and frees slots. It is not for a pure 4 to 20 mA rack, where a standard analog input does the job for less. The per-point isolation matters where sensors share a noisy ground, so a fault stays local. For a small skid with one sensor kind a single-type card is simpler; this one pays off on the mixed group.
Seat the module in any chassis slot and land the wiring on a 36-pin terminal block for the eight isolated channels. Ground the chassis to panel earth and keep sensor shields continuous to avoid noise on the millivolt points. Add the 250 mA at 5 V and 150 mA at 24 V draw to the rack budget before the supply is sized. The controller is inspected and tested before shipping, covered for 12 months.
| Catalog number | 1756-IRT8I |
| Manufacturer | Allen-Bradley |
| Product family | ControlLogix 1756 |
| Product type | PLC Module |
| Module Type | Input Module |
| Inputs | 8 Isolated Channels |
| No. of Inputs | Eight (8) Point Isolated RTD / Thermocouple / milivolt |
| Current Draw (5.1 Volts) | 200 milliamps |
| Power Dissipation (Maximum) | 4.6 Watts |
| Backplane Current (5Volts) | 250 mA |
| UPC | 10885630245420 |
| Backplane Current (24 Volts) | 150 mA |
| Power Dissipation (Max) | 4.6 W |
| Mounting | 1756 chassis slot (4, 7, 10, 13 or 17 slot chassis) |
| Enclosure rating | Open style, IP20 |
| Operating temperature | 0 to 60 °C (32 to 140 °F) |
| Storage temperature | -40 to 85 °C (-40 to 185 °F) |
| Relative humidity | 5 to 95%, non-condensing |
| Communication options | EtherNet/IP, ControlNet or DeviceNet through 1756 bridge modules |
| Certifications | CE, cULus |
| Condition | Tested and cleaned, in good working order |
| Warranty | 12 months |
| Place of origin | Made in USA |
| Stock status | In stock |








