Feeding from a 342-528 V RMS three-phase supply, 2198-C4004-ERS is the entry point of the 400 V group in the Kinetix 5300 family. It delivers 0.86 kW of continuous output power at 1.6 amps, which suits small rotary axes, feed rolls and tool slides on a larger machine. Motion is integrated over EtherNet/IP, so the axis is configured in the controller. At 0.86 kW the module leaves plenty of room in a panel that already carries larger drives.
Small currents, large voltage window
Main input current is only 1.24 amps, peaking at 3.59 amps, from a 47-63 hertz supply, with control power at 21.6-26.4 volts DC. An internal shunt switching at 775/765 volts through a 100 ohm, 30 watt resistor handles modest regenerated energy. At this power level the currents are small enough that terminal torque, not conductor size, is usually what causes trouble in the field.
Fitting a 400 V module into a 480 V panel
The 400 V input window means this drive is wired to a 480 V class distribution, not to a 240 V bus. Control is CIP Motion over EtherNet/IP. Enclosure is open style, IP20, for cabinet mounting, ambient 0 to 50 °C, storage -40 to 85 °C, and the unit carries CE and cULus marks. Clearance above the module matters because the shunt resistor sits inside the housing. Mounting it low in the cabinet, with free air above, is the simplest way to keep the resistor inside its rating.
First power up with the shaft free
On a replacement, check the incoming voltage window before anything else, since a 240 V feed will not run this model. Land the earth, then the motor leads, then the network drop, and power up with the axis uncoupled. Verify the node appears and jog both directions slowly. Keep the old parameter set for reference. Tested and cleaned, in good working order. Every part passes a bench check before it ships, covered for 12 months.
| Catalog number | 2198-C4004-ERS |
| Manufacturer | Allen-Bradley |
| Product family | Kinetix servo drive |
| Product type | AC Drive |
| Product Description | Servo Drive |
| AC Input Voltage | 342-528 Volts RMS |
| AC Input Frequency | 47-63 Hertz |
| Main AC Input Current | 1.24 Amps |
| Peak AC Input Current | 3.59 Amps |
| Control Power Input Voltage | 21.6-26.4 Volts DC |
| Continuous Output Current | 1.6 Amps |
| Continuous Output Power | 0.86 kW |
| Internal Shunt On/Off | 775/765 Volts |
| Internal Shunt Resistor | 100 Ohms |
| Internal Shunt Power | 30 Watts |
| Control | Integrated motion over EtherNet/IP (CIP Motion) |
| Enclosure rating | Open style, IP20 |
| Operating temperature | 0 to 50 °C (32 to 122 °F) |
| Storage temperature | -40 to 85 °C (-40 to 185 °F) |
| Certifications | CE, cULus |
| Condition | Tested and cleaned, in good working order |
| Warranty | 12 months |
| Place of origin | Made in USA |
| Stock status | In stock |













