The extremely compact SINUMERIK OP 08T operator panel front supports the distributed installation of the operator panel front and CNC. The SINUMERIK OP 08T operator panel front contains a membrane keyboard with 75 keys (layout as SINUMERIK KB 310C full CNC keyboard), as well as 2 × (8 + 2) horizontal and 2 × 8 vertical softkeys.
The operator panel front is mounted from the rear using special clamps included in the scope of supply.
Product No. / Product Description
Listprice / Your price
SINUMERIK OPERATOR PANEL FRONT OP 08T; 8″ TFT (640 X 480) WITH MEMBRANE KEYS AND INTEGRATED TCU This product contains items supplied by third parties and may only be resold in conditions where the same protection level applies as under the standard conditions of delivery of Siemens AG for hardware products. If required, Siemens AG can supply these terms and conditions.
The 2 × 8 vertical softkeys can be used as direct keys with SINUMERIK 840D sl.
Signal transmission between operator panel front and PCU/NCU via Industrial Ethernet
Mixed operation with one operator panel front directly at the PCU is possible. Operation on an SINUMERIK OP 08T has the same authorization rights as operation on an operator panel front connected directly to the PCU. The operator panel in passive mode shows a darkened screen.
The distance to the operator panel fronts is determined by the maximum distance between two network nodes/access points (100 m/328 ft).
The SINUMERIK OP 08T operator panel front can be used for: